Support Center

What if the monitor is blank or shows “no signal”?

2018-06-13 15:01:57 yeskamo Read


What if the monitor is blank or shows “no signal”?


YESKAMO system is truly plug and play. The monitor will play video after you connect the NVR to monitor with VGA/HDMI cable and plug the whole system to power socket.

If you cannot get any display on monitor from the NVR system, usually it is caused by resolution compatibility issue.

The default output resolution of the NVR is 1280*1024, Please check what's your monitor resolution input and adjust the NVR resolution to match your monitor.

1. Connect the NVR to any other screen via VGA to enter the system; (or you may also try any other screen via HDMI to see if you can enter the NVR system)

2. When you are able to login/enter the system, click right button on mouse, go to System Setup > General Setup > Screen Setup > VGA resolution; change it to match your primary monitor > apply to save the setting.

3. Connect the NVR to your primary monitor via HDMI/VGA cable. You should have it worked with the screen. 

Once enter the NVR Recorder menu, right click mouse > system setup > general setup > Screen setup , adjust the resolution match with your monitor.

图片.png